Blog

ZLJM-A DC contactor is mainly used to control DC circuits (main circuit, control circuit and excitation circuit, etc.).

A circuit breaker is a switching device that can close, carry and break current under normal loop conditions and can close, carry and break current under abnormal loop conditions within a specified time.

The world's first circuit breaker was born in 1885, it is a combination of a knife start and an overcurrent release.

The operating principle of the DC contactor is similar to that of the AC contactor, but the magnetic field energy stored by the inductive load is instantaneously released when the DC is disconnected, and the high-energy arc generated at the breakpoint req

The shunt is actually a resistor with a small resistance.

1. Application in charging pile (machine)

(1) Select the rated pressure drop specification of the shunt according to the number of mV marked on the dial of the current meter (or current-voltage multimeter) (usually 75mV or 45mV is commonly used). If the current meter used does not have this value, use the following formula to calculate the voltage limit of the meter, and then select the rated pressure drop specification of the shunt.

The DC contactor is also composed of an electromagnetic mechanism, a contact system, and an arc extinguishing device.

When the coil of DC contactorl is energized, the coil current generates a magnetic field, so that the static iron core generates electromagnetic attraction to attract the moving iron core